Filter
Top Products
Installation checklist
Your installer MUST have completed and checked the following:
The DishDrawer
®
is square and level.
The DishDrawer
®
is fastened securely to the cabinetry.
Ensure moisture protection tape has been applied and the cabinet is sealed according to the
DishDrawer
®
Installation Instructions.
The DishDrawer
®
opens and closes freely. The DishDrawer
®
must be free to close completely with
no resistance from cabinetry.
For the integrated models, check the
5
/
16
” air gap has been achieved in the correct place.
The power supply is connected and switched on.
The inlet water hose is connected and turned on. There should be no leaks.
The drain hose(s) are connected and there are no leaks. There must be no kinks, or obstructions
in the drain hose(s).
The spray arm is in the center and can freely rotate.
The rinse program has been run.
The water level will be below the stainless steel filter plate at the end of the wash program. It is
normal to find some water in the drain filter area.
Set the water softener to the correct water hardness for your area.
Important!
The installer is responsible for the DishDrawer® installation. Incorrect installation is not
covered by warranty.