Filter
Top Products
37
Solutions To Common Problems
Temperatures Are Too Warm
Problem Cause Correction
Freezer/
Refrigerator
temperature is too
warm.
•Doors are opened too
frequently or too long.
•Door is slightly open.
•Warm air enters the refrigerator whenever the door is
opened. Open the door less often.
•See Problem section, Opening/Closing of Doors/Drawers.
Freezer
temperature is too
warm. Refrigerator
temperature is
satisfactory.
•Freezer control is set too
warm.
•Setfreezercontroltoacoldersetting.Allow24hoursfor
temperature to stabilize.
Refrigerator
temperature is
too warm. Freezer
temperature is
satisfactory.
•Refrigerator control is set
too warm.
•Setrefrigeratorcontroltoacoldersetting.Allow24hours
for temperature to stabilize.
Temperature in
the Meat Keeper
is too warm (some
models).
•Meat Keeper temperature
control is set too warm.
•AdjustMeatKeepertemperaturecontroltoacolder
setting.
Water/Moisture/Frost Inside Refrigerator
Problem Cause Correction
Moisture collects on
inside of refrigerator
walls.
•Weather is hot and humid.
•Door is slightly open.
•Door is opened too often or
too long.
•Open containers.
•The rate of frost buildup and internal sweating increases.
•See Problem section, Opening/Closing of Doors/Drawers.
•Open door less often to allow internal temperature to stabilize.
•Keep containers covered.
Water collects on
bottom side of
drawer cover.
•Vegetables contain and give
off moisture.
•Moisture on the bottom side of the cover is not unusual.
•Move humidity control (some models) to lower setting.
Moisture collects in
bottom of drawer.
•Washed vegetables and fruit
drain while in the drawer.
•Fruits and vegetables are kept
past their prime
•Dry items before putting them in the drawer. Water collecting in
bottom of drawer is normal.
•Routinely clean out old fruits and vegetables especially if they
begin to break down.
Moisture collects on
outside of refrigerator
or between doors.
•Weather is humid.
•Door is slightly open,
causing cold air from inside
refrigerator to meet warm air
from outside.
•This is normal in humid weather. When humidity is lower, the
moisture should disappear.
•See Problem section, Opening/Closing of Doors/Drawers.
Perfect Temp Drawer (some models)
Problem Cause Correction
Display does not
illuminate or shows
“CE”.
•Connector not connected or
loose.
•Remove pan and insure connector is fully engaged. (See Storage
Features section)
Display shows “LOC”
when buttons are
pressed.
•Drawer in control lock mode. •Press and hold control lock button for three seconds to take
drawer out of control lock mode. (See Storage Features section)