Filter
Top Products
21
• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a “new” smell when first
installed. This is normal.
• Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
21).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2 Do not add detergent.
3 Select the NORMAL WASH cycle. Press
START/CANCEL pad and close door.
4 Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
5 Close and latch door and allow cycle to
finish.
NOTE
If these conditions persist, a home water
softener should be considered.
Solutions to Common Problems
ERROR CODES
In certain situations which are critical to
machine function and safe operation.
Error codes will be shown in the status
window on the EIDW6305.
Er 01
Leak Detector - When water is detected under
the tub.
Er 02
Thermistor - When thermistor/turbidity module
fails
Er 03
Wash Pump - Wash pump not operating
Er 04
Drying Damper - Drying damper not operating
Er 05
Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan
Er 06
Lower Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the lower fan
Er 07
Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve
Er 08
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Er 09
Communications - Communication failure be-
tween main user board and power supply
Er 10
Mains Relay - Failure in the mains power relay
Er 11
Drain Valve - Time out before finding a state for
the drain valve
Er 12
Drain Valve - The drain valve is running when it
should be off
Er 13
System wide - Lost control of the State Machine
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).
REMOVING SPOTS AND
• Check to see if the water supply is
turned on.
• Add 1/2 cup of water to the bottom of the unit
and start again.off.
DISHWASHER HAS AN ODOR
DISHWASHER WON’T FILL
FILM