Filter
Top Products
Installing Your Cooker
Your stability bracket
You can buy a stability bracket from your supplier and it
can fitted as follows:
● Place the cooker in position and draw a pencil line level
with the front edge.
● Remove the cooker and mark off 450mm from the
pencil line to locate the front edge of the lower
bracket.
● Fix the bracket to the floor. Measure from floor level to
engagement edge in the back of the cooker and add
3mm.
● Assemble the underside of the top part of the bracket
to this height.
● See the drawings for the location of the bracket and
the recommended positioning.
Levelling
Once your cooker is secure, place a spirit level onto a
baking tray, on an oven shelf.
These cookers are fitted with adjustable feet and wheels
which will allow you to adjust the height of the appliance
until it is level. The feet, fitted to the front of the cooker,
are adjusted by turning them clockwise, or anti clockwise
- depending on how much you need to adjust the height.
The wheels fitted to the rear of the appliance, are adjust-
ed via the screws accessed through the front face of the
cooker plinth. To raise the cooker, turn screws clockwise,
or anti-clockwise to lower.
Plinth Cover
A decorative plinth cover is supplied with with the cooker,
packed behind the product in transit. It is fitted to the
product plinth via the two brackets fitted. The cover is fit-
ted with the slots uppermost, and fixed using the screws
supplied partially inserted in the brackets.
Stability
b
1 Pencil line
on floor
2 Centre
of range
3
450
mm
Front edge for
lower bracket
4
5 Underside of top b
slots into engage
m
edge in back of co
o
Rear wall
Model viewed from rear
Locate stability bracket here
X
Rear
plinths
28