Filter
Top Products
Installing Your Cooker
Connecting to the gas supply
The inlet to the appliance is ISO 7 - Rp
1
⁄2
” internal thread
situated towards the top right corner of the rear.
Fit the bayonet connection. This should be located so as
to ensure that the flexible hose does not kink.
Use a 900mm - 1125mm length of flexible hose.
Ensure that all pipe work is of the correct rating.
Natural Gas - Flexible connections should comply with
BS 669. Parts of the appliance likely to come into contact
with a flexible connector have a temperature of less than
70˙C.
LP Gas - For flexible connections use a bayonet type
hose, suitable for use on LP Gas up to 50mbar pressure
rise and 70˙C temperature rise. The flexible hose should
be coloured black with a red stripe, band or label. If in
doubt, contact your supplier.
For conversion to LPG, a conversion kit can be purchased.
Contact the Electrolux helpline, quoting kit reference
012860201.
After installation make sure all connections are gas
sound.
Commissioning
Pressure settings:
G20 Natural Gas @ 20mbar
G30 Butane @ 28-30mbar
G31 Propane @ 37mbar
Hob
Turn on gas supply and check for soundness at the hot-
plate injector. Light two burners and check that the pres-
sure is correct.
Grill
Turn the control knob to the full on position, allow the grill
to operate for a few minutes.
Oven
Turn the control knob to the full on position, allow the
oven to operate for a few minutes
.
30