Filter
Top Products
27
BEFORE CLEANING ALWAYS ALLOW
THE COOLING FAN TO COOL THE
APPLIANCE DOWN BEFORE SWITCHING
OFF THE ELECTRICITY SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided to prevent damaging the
stainless steel finish.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur. Regularly wipe over
the control panel, oven doors and handle using a soft
cloth and hot soapy water. To prevent streaking
finish with a soft cloth. Stainless steel cream
cleaners are abrasive and should be avoided as
they may damage the surface finish.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
CLEANING INSIDE THE MAIN OVEN
The Stayclean surface inside the Main Oven should
not be cleaned manually. See page 29 'Care of
Stayclean Surfaces'.
The vitreous enamel oven base can be cleaned using
normal oven cleaners or aerosol oven cleaners with
care. Ensure that the manufacturers instructions are
followed and that all parts are well rinsed afterwards.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements or the door seal as this may cause
damage.
CLEANING INSIDE THE TOP OVEN/GRILL
COMPARTMENT
The vitreous enamel coating in the top oven/grill
compartment can be cleaned using normal oven
cleaners or aerosol oven cleaners with care. Ensure
that the manufacturers instructions are followed and
that all parts are well rinsed afterwards.
Aerosol cleaners must not come into contact with
the door seal as this may cause damage.
REMOVING AND REPLACING WIREWORK
SIDE RUNNERS
Remove all shelves and furniture from the oven.
Hold the bottom of the wirework runners and draw
the runners towards the centre of the oven. Unhook
from the top and remove.
Clean the wirework runners by soaking in very hot
soapy water, mild abrasives may be used.
To replace, hook the wirework side runner into the
cavity, slide back and press into place. Ensure the
wirework runners are firmly in position before
replacing the oven shelves.
CARE AND CLEANING
CAVITY CENTRE
BRACKET