Filter
Top Products
28
CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle can
be washed in the dishwasher.
The grill pan, grill pan grid, grill deflector, meat tin,
oven shelves and wirework runners may be cleaned
using a soap impregnated steel wool pad. Soaking
first in hot soapy water will make cleaning easier.
CLEANING THE DOOR GLASS
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
· Household detergents and bleaches
· Impregnated pads unsuitable for non-
stick saucepans
· Brillo/Ajax pads or steel wool pads
· Chemical oven pads or aerosols
· Rust removers
· Bath/Sink stain removers
CLEANING BETWEEN THE OUTER AND
INNER DOOR GLASS
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1. Open the oven door slightly to gain access to the
two cross head screws on the top of the oven
door.
2. Loosen the two screws using a Pozidrive
screwdriver.
3. Hold the door glass securely in place with one
hand before removing the screws completely with
the other hand.
The screws and washers retain the trim on the
top of the grill/top oven door.
Note the position of the trim on the door.
4. Using both hands, gently tilt the top of the door
glass towards you, lift slightly to disengage the
locators from the two bottom brackets. The door
will remain in a parked position at an angle of
approximately 30°.
5. Clean the outer and inner glass using hot soapy
water or Hob Brite may be used with care. DO
NOT use Hob Brite on the Stainless Steel or
painted finishes. DO NOT try to clean the foil
which is inside the door. The foil is there to help
keep the door cool, if it is damaged it will not work.
Ensure that all parts are well rinsed and
thoroughly dried before attempting to replace the
outer door.
TO REPLACE THE OUTER GLASS
1. Open the oven door with care and place in the
park position at an angle of approximately 30°.
2. Holding the oven glass with both hands, gently
place the locators into the holes of the brackets
at the bottom of the oven door.
3. Push the top of the oven glass towards the oven
door, ensuring the screw location holes line up.
4. Ensure the trim is correctly positioned on the top
oven / grill door.
5. Hold the glass in place at the top of the door.
Insert the cross head screws into the location
holes. Give the screws one turn to ensure the
glass is secure.
6. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
Do Not attempt to use the oven without the
glass being in place.