Filter
Top Products
12 electrolux first use
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
the programme knob and the
start/cancel button.
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. The dishwasher must be switched
off.
Keep the start/cancel button
pressed and turn the programme
knob clockwise until the
programme marker corresponds
with the first washing programme.
2. Release the start/cancel button,
the On/Off and start/cancel
indicator lights start to flash
indicating that you have activated
the water softener setting function.
3. At the same time, the end of
programme indicator light starts to
flash.
The current level is indicated by
the number of flashes of the
indicator light end of programme
and a pause of about 3 seconds.
Examples:
5 flashes, pause, 5 flashes, pause,
etc... = level 5
6 flashes, pause, 6 flashes, pause,
etc... = level 6
4. To change the level, press the
start/cancel button. Each time the
button is pressed the level
changes.
Examples:
if the current level is 5, by pressing
start/cancel button once, level 6 is
selected.
if the current level is 10, by
pressing start/cancel button once,
level 1 is selected.
5. To memorise the operation, switch
off the dishwasher by returning the
programme knob to the Off
position.
117989 84/0en 20-02-2007 17:10 Pagina 12