Filter
Top Products
34 electrolux something not working
Malfunction Possible cause and solution
The programme does not start ● The dishwasher’s door has not been
properly closed. Open door control light
illuminated.
Close the door.
● The main plug is not plugged in.
Insert the main plug.
● Delay start has been set.
If dishes are to be washed immediately,
cancel the delay start.
● The fuse has blown out in the household
fuse box.
Replace the fuse.
Once these checks have been carried
out; switch on the appliance, press
the button of the programme that was
running before the intervention of the
alarm and close the dishwasher’s
door.
The programme will continue from the
point at which it was interrupted.
If the malfunction or fault code
reappears contact the Service Force
Centre.
For other fault codes not described in
the above chart, please contact your
Service Force Centre.
Contact your local Service Force
Centre, quoting the model (Mod.),
product number (PNC) and serial
number (S.N.).
This information can be found on the
rating plate located on the side of the
dishwasher door.
So that you always have these
numbers at hand, we recommend you
to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The flashing of the point-shaped
optical signal on the floor beneath the
dishwasher’s door will not be visible if
the appliance has been installed
higher up with a furniture door
mounted flush.
117990 17/0en 2-01-2007 11:46 Pagina 34