Filter
Top Products
16
6. Separate parts A, B, C, D as shown in the figure.
PR266
A
B
C
D
10. Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
8mm
PR167
A
B
9. Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm at
8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
PR168
PR167/1
D
B
11. Fix cover (D) on guide (B) until it clips into place.
PR33/2
C
A
20mm
A
50mm
PR166
7. Place guide (A) on the inside part of the furniture
door, upper and lower position as shown in the
figure and mark the position of external holes. After
having drilled holes, fix the guide with the screws
supplied.
8. Fix cover (C) on guide (A) until it clips into place.