Electrolux EUF14800 Freezer User Manual


 
15
INSTALLATION
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR, YOU
MUST ENSURE THAT IT IS MADE UNUSABLE TO PRE-
VENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for your
appliance, you may wish to reverse the way in which the
door opens. To do this, refer to instructions under “Door re-
versal”.
Positioning
The appliance should only be installed at a location where
the ambient temperature corresponds to the climate clas-
sification indicated on the rating plate, which is located on
the inside left of the appliance.
The following table shows which ambient temperature is
correct for each climate classification.
SN +10¡C to +32¡C
ST +18¡C to +38¡C
The appliance should be located in a dry atmosphere, out
of direct sunlight and away from continuous heat and ex-
treme temperature, e.g. not
next to a boiler or radiator or in a very cold room e.g. an
outhouse. If these temperatures are exceeded i.e. warmer
or colder, then the appliance may not operate correctly.
For building-in and door reversal instructions please refer
to the relevant instructions on the following pages.
Door reversal
The appliance’s door has been locked in position for trans-
port by means of pins on both sides. According to the door
opening direction, remove relevant pins at the top and at
the bottom.
Attention!
After completion of the door reversing opera-
tion, check that the door gasket adheres to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating up the part involved with a nor-
mal hairdryer on a low setting.