Filter
Top Products
7
High-Temperature Alarm
If temperature inside the freezer compartment rises too
high (for instance, in the event of a power failure), it will trig-
ger the following indications:
- temperature readout blinks;
- symbol 3 blinks;
- display turns red;
- buzzer beeps.
When temperature is back to normal:
- the buzzer stops beeping;
- the temperature readout keeps blinking;
- the display stays red.
When you press the Alarm Reset button C, readout 4
shows the actual peak temperature reached inside the
compartment for 5 seconds, and then the display will stop
blinking and return to its normal colour.
During an alarm, you may turn off the buzzer by pressing
button C; the display will stay red until normal operating
conditions are restored.
Door Ajar alarm
The Door Ajar alarm will activate if the door is left ajar for
about 1 minute.
A Door Ajar alarm condition is indicated by:
- symbol (1) blinking;
- the display turning red;
- the buzzer beeping.
Press button (C) to stop the buzzer. When normal operating
conditions are restored (closed door):
- the buzzer stops beeping.
Storage of frozen food
When you first start the freezer or if the freezer has been
out of use for some time, wait at least 12 hours before stor-
ing frozen food in your appliance.
If you need to store large quantities of food and wish to use
the full capacity of your appliance, you may remove all
drawers and baskets (except the bottom drawer) and place
the food directly on the (cold) shelves. Products must only
be stacked up to the maximum capacity mark (where pres-
ent) on the cabinet wall.
Important
Food thawed accidentally (for instance, during a power
outage) should be used within a short time or cooked
and refrozen immediately (after cooling to room tem-
perature) if the appliance has been out of operation
longer than the safe "Storage time in the event of a fail-
ure" indicated in the technical data chart.