Filter
Top Products
4. Snap vent grill (B) and hinge cover (E) into position.
Apply blanking covers (C-D) as indicated.
5. Separate parts Ha, Hb, Hc, Hd as shown in the figure.
6. Place guide (Ha) on the inside part of the furniture door,
up and down as shown in the figure and mark the position
of external holes. After having drilled holes, fix the guide
with the screws supplied.
8. Open the appliance door and the furniture door at 90¡. In-
sert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture door and
mark the holes as indicated in the figure.
9. Remove the squares and mark a distance of 8 mm from
the outer edge of the door where the nail must be fitted (K).
10. Place the small square on the guide again and fix it with
the screws supplied. Should the alignment of the furniture
door be necessary, use the clearance of slots. At the end of
this procedure, it is necessary to check if the door of the
furniture closes properly.
11. Fix cover (Hd) on the small square (Hb) until it clips into
place.
7. Fix cover (Hc) on guide (Ha) until it clips into place.
18