Filter
Top Products
Operating Instructions
11
1
The hardness range cannot be set if a programme is running. If you
have inadvertently started a programme (an LED indicator is constantly
illuminated) the programme must be cancelled by pressing the appro-
priate button.
1. The appliance must be switched off.
2. Press the water softener button and the function button simultane-
ously and hold them down.
3. In addition press the ON/OFF button.
4. At first the LED indicator for the water softener button will light up
continuously for 5 seconds and then begin to flash.
– The number of flashes corresponds to the hardness setting.
– The sequence of flashes is repeated several times after a 5 second
pause.
5. Each time you press the water softener button the hardness setting will
go up by 1.
(Exception: Hardness setting 1 follows after hardness setting 5.)
6. If the hardness setting is changed, the LED indicator for the water sof-
tener button will confirm the change by staying alight continuously for
5 seconds and then flashing again.
7. The number of flashes corresponds to the new hardness setting.
8. The sequence of flashes is repeated several times after a 5 second
pause.
9. Once the hardness setting is correct, press the ON/OFF switch.
The hardness setting is then saved.