Filter
Top Products
Operating Instructions
22
Start the wash programme
0 1. Check that when the dishes and cutlery are loaded in the dishwasher
the spray arms are free to rotate.
2. Open the water tap fully.
3. Shut the door.
4. Press the ON/OFF button. ON/OFF button indicator comes on.
5. Press the button for the programme required (see “Programme Table“).
The programme indicator lights up. One or two lights will flash in the
multidisplay. During this time it is possible to reselect the programme.
The selected washing programme begins after approx. 6 seconds. The
current wash programme stage will always be shown in the multi-dis-
play.
3
If the top light and/or the middle light in the multi-display flash after
the programme has started please read the section “What to do, if...“.
Interrupting or stopping the wash programme
3
Only interrupt a wash programme in progress if it is absolutely neces-
sary. After the appliance door has been closed again the air that has
entered will be quickly heated and expand. As a result water may pene-
trate the base of the appliance and trigger the anti-flood system.
Interrupting the wash programme by opening the door of the dish-
washer
1
Hot steam can escape from the appliance when the door is opened.
Open the door carefully.
0 1. Open the door of the dishwasher. The wash programme will stop.
2. Lights are flashing in the multi-display.
3. Shut the door. The wash programme will continue.
Cancelling the wash programme
0 1. Press the button for the wash programme that is running and hold it
down until the programme indicator for the wash programme goes out.
2. Release the programme button; the wash programme has been can-
celled.
3
Switching off the dishwasher interrupts a selected wash programme; it
does not cancel it. The wash programme will continue when the appli-
ance is switched on again.