Filter
Top Products
Installation instructions
42
Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety valve
is next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water.
Please take care when installing the water inlet hose:
- The electrical cable for the safety valve is in the double-walled
water inlet hose. Do not immerse the water inlet hose or the
safety valve in water.
- If water inlet hose or the safety valve is damaged, remove the
mains plug immediately.
- A water inlet hose with safety valve must only be replaced by a
specialist or by the consumer services department.
- Place the water inlet hose in such a way that it is never higher
than the bottom edge of the safety valve.
- The inlet hose should be connected so it hangs vertically down from
the supply tap.
152963040en per uk.qxp 22/03/2004 9.54 Pagina 42