Filter
Top Products
INSTALLATION
Location
The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
The aappliance mmust bbe eearthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
specialist technician.
The MManufacturer ddeclines aall
responsibility iif tthe aabove ssafety
precautions aare nnot oobserved.
This appliance complies with the
following E.E.C. Directives:
- 887/308 EEEC
of 2/6/87 relative to radio
interference suppression.
- 773/23 EEEC
of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
- 889/336 EEEC
of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Door reversibility
The appliance’s door have been
locked in position for transport by
means of pins on both sides. According
to the door opening direction, remove
relevant pins at the top and at the
bottom.
Instructions for
totally built-in appliances
Building-in instructions
For safety reasons, minimum ventilation
must be as shown in Fig.
Attention: kkeep vventilation oopenings
clear oof oobstruction.
It is necessary that the niche is
provided with a ventilation conduct
having the following dimensions:
Depth 50 mm
Width 540 mm
Dimensioned drawings
See „ Installation Instructions“
supplied.
50 mm
min.
200 cm
2
200 cm
2
min.
D567
electrolux 35