Filter
Top Products
11
Wiring Diagram
Commissioning
When the hob has been fully installed it will be
necessary to check the minimum flame setting.
To do this, follow the procedure below.
1. Turn the gas tap to the MAX position and
ignite.
2. Set the gas tap to the MIN flame position
then turn the control knob from MIN to
MAX several times. If the flame is unstable
or is extinguished follow the procedure
below.
Procedure:
1. Re-ignite the burner and set to MIN.
2. Remove the control knob.
3. To adjust, use a thin bladed screwdriver
and turn the adjustment screw (it may be
located inside the gas tap shaft or on the
body of the gas tap itself, according to
different models - see diagram). Adjust the
minimum gas flow level until the flame is
steady and does not extinguish, when the
knob is turned from MIN to MAX. Repeat
this procedure for all burners.
Minimum adjustment screw
A. IGNITOR SWITCH
B. IGNITOR UNIT