Filter
Top Products
Removing e Doors
Getting through narrow spaces
if your refrigerator will not fit through an entrance area,
you can remove the doors, Check first by measuring the
entrance.
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges with a
pencil. This makes reinstallation easier.
To prepare for removing the doors:
Make sure the electrical power cord is unplugged
from the wall outlet.
2 Open the freezer drawer and remove the toe
grille (see "1nstallation" section),
3 Remove any food from the door shelves and
close the doors,
To remove the top hinge covers"
1 Remove the two (2) screws from each cover over
the top door hinges.
2 Lift inside edge of hinge cover and tilt back.
Front Rear
C_ie_ Screw LCowr
TopHl_ \!,/_'._ - sc,_
HI Oround
Disconnect the harness by grasping both sides of
the connector firmly, depress the latch, and pull
apart. Remove the two (2) screws from the top
hinge, Lift the door off of the bottom hinge and
set it aside.
J_x]r Fre_f
cow--_ co_r _r_
"&_b ,,,-q'--.I1| --.>HI.g_,
Detach the water tube from the connector
located behind the refrigerator and pull the tube
back out to the front of the unit. The connector
releases when you press inward on the outer
sleeve while pushing the tube toward the
connector then while continuing to hold in the
sleeve, pull the tube away.
NOTE
DO NOT remove the ground screw from hinge.