Filter
Top Products
13
the Unit of Measure Indicator light starts flashing.
- To change the SET temperature, press SET/DOWN button or
MANUAL DEFROST/UP button within 15 seconds
SET
or
- To store the new set value, wait until it stops flashing to exit
the program
SET
if a selection is not made after 15 seconds, the last value dis-
played will be confirmed automatically and the chamber tem-
perature display is restored.
Example of setting:
- switch on the appliance
B.2.7 CHECKING HINGES
Have the hinges of the appliance checked every two years by a
technician. If necessary, adjust and grease the hinges.
C.1.1 CONTROL PANEL
2
3
4
1
CATEGORY
HUM
HIGH
%
SET
HACCP
ACCESS TO
FOOD CATEGORIES
HIGH HUM.
ON/OFF
SERVICE
ALARMS
PRINT
TEMPERATURE/
CATEGORY
SELECTION
MANUAL
DEFROST
COMPRESSOR
S TATU S
POWER SUPPLY
S TATU S
HACCP
ALARMS
7 DAYS
REPORT
POWER ON/OFF
1-Access to Food Categories button
2-High humidity ON/OFF button
2a - High humidity indicator light
3-Service alarms button
3a - Service alarms indicator light
4-Manual defrost / UP button
5-Set temperature / Category selection / DOWN button
6-HACCP alarms button
7-Display
8-Compressor status indicator light
9-Power supply status indicator light
10 - Power ON/OFF button
C.1.2 INITIAL SWITCH-ON AND TEMPERATURE ADJUSTMENT
The appliance features an ON/OFF switch for activating the
appliance.
Turn on the appliance by pressing the ON/OFF button:
To set the chamber temperature, follow these steps:
- press and hold SET/DOWN button for 5 seconds,
SET
the SET POINT value appears on the display
C.1 OPERATIONS and USER
INSTRUCTIONS
1
2a 3a 4
7
89
23 5 6 10