Filter
Top Products
What to do if ...
21
The food is too warm.
Temperature is not
properly adjusted.
Please look in the "Initial
Start Up" section.
Door was open for an
extended period.
Open the door only as long
as necessary.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
Turn the temperature
regulator to a colder
setting temporarily.
The appliance is near a
heat source.
Please look in the
"Installation location"
section.
Interior lighting does not
work.
Light bulb is defective.
Please look in the
"Changing the Light Bulb"
section.
Heavy build up of frost,
possibly also on the door
seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the
leaking sections of the
door seal with a hair dryer
(not hotter than approx.
50°C). At the same time
shape the warmed door
seal by hand such that it
sits correctly.
Unusual noises.
Appliance is not level. Readjust the feet.
The appliance is touching
the wall or other objects.
Move the appliance
slightly.
A component, e.g. a pipe,
on the rear of the
appliance is touching
another part of the
appliance or the wall.
If necessary, carefully
bend the component out
of the way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts
after a period of time.
Water on the floor or on
storage shelves.
Water drain hole is
blocked.
See the "Cleaning and
Care" section.
Malfunction Possible Cause Remedy