Filter
Top Products
14
Prior to Initial Start-Up
1
Before connecting the appliance to the mains and putting it into ope-
ration for the first time, leave the appliance to stand for 30 minutes if
it was transported upright. After transport on its side, the appliance
must be left to stand for 2 hours before putting it into operation. This is
necessary to allow the oil to flow back into the compressor. Otherwise
the compressor may be damaged.
0 1. Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Maintenance and Cleaning").
Starting Up and Regulating the Temperature
Control Panel
1 Ambient switch with yellow light
2 Mains power light (green)
3 Temperature regulator and ON/OFF switch
The temperature regulator is also the ON/OFF switch.
A coin is needed to turn the temperature regulator. This makes it more
difficult to change the temperature setting accidentally (child
protection).
Position "0" means:
Off
Position "1"means:
Highest interior temperature (warmest setting)
Position "4" means:
Lowest interior temperature (coldest setting)