Filter
Top Products
Installation
The refrigerator should be located away
from direct sunlight and heat sources such
as registers, radiators or any cooking
products.
In accordance with ISO standards, your
refrigerator is performance rated at Class N,
16°C to 32°C (61°F to 90°F) or at Class ST,
18°C to 38°C (65°F to 100°F). Internal
temperatures may be affected by such
factors as its location, ambient temperature,
and the frequency of door openings.
Allow space around the unit for good air
circulation. Allow a 25mm (1 inch) space
behind and a 10mm (3/8 inch) space above
the refrigerator for adequate ventilation.
In a recessed installation, allow an extra
10 - 15 mm (½ inch) on each side for ease
of installation. If the side of the unit will be
placed against a wall, allow 13 mm
(½ inch) space for proper door opening.
TIPS:
• Proper air circulation and leveling will
assure efficient operation of yourrefrig-
erator.
• Do not use an extension cord.
• If refrigerator has an ice maker, locate it
near a water supply.
• Remove all packing materials and tape.
• Wash interior with a mild soap and
warm water.
• Do not use a razor blade or knife to
remove tape.
Installation
TO ADJUST THE FRONT ROLLERS
1. Open both doors.
2. Remove the toe grille by pulling it
straight out.
3. Adjust the rollers by turning each roller
adjusting bolt with a wrench until the
refrigerator is level and stable. The rear
rollers are not adjustable.
4. Check both doors to ensure that the
seals touch the cabinet on all sides.
5. Replace the toe grille by lining up the
retainers with the holes and pushing the
grille straight on.
TIPS:
• If the freezer door is higher than the
refrigerator door, raise the right corner
and/or lower the left corner until the
doors align across the top of the cabinet.
• If the refrigerator door is higher than
the freezer door, raise the left corner
and/or lower the right corner until doors
align across the top of the cabinet.
4