Electrolux SIM 533 Range User Manual


 
IMPORTANT - SAFETY REQUIREMENTS
This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations Current Editions
and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British Standard Codes of
Practice - BS.6172, BS.5440: Part 2 and B.S.6891. All British Standards must be 'Current Editions'.
PROVISION FOR VENTILATION
This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in
accordance with the current installation regulations. Particular attention shall be given to the relevant requirements
regarding ventilation.
The room containing the appliance should have an air supply in accordance with BS. 5440: Part 2 Current Edition. All
rooms require an openable window or equivalent and some rooms will require a permanent vent as well. For room
volumes up to 5m³ an air vent of 100cm² is required: for room volumes between 5m³ and 10m³ an air vent of 50cm²
is required. If the room has a door that opens directly to the outside, no air vent is required. For room volumes that
exceed 11m³ no air vent is required. If there are other fuel burning appliances in the same room, BS.5440: Part 2
Current Edition should be consulted to determine the requisite air vent requirements.
Prolonged intensive use of the appliance may call for additional ventilation, for example opening a window, or more
effective ventilation, for example increasing the level of mechanical ventilation where present.
MOVING YOUR APPLIANCE
You may damage some soft or badly fitted floor coverings when you move the appliance. The floor covering under the
appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you
could remove the floor covering.
To move the appliance open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull
the appliance forward. When you replace the appliance push it back to the stop and make sure there is the same gap
at each rear corner.
30
INSTALLATION INSTRUCTION
FOR YOUR SAFETY
Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection,
as described in the installation instructions. If this is the case contact the person who installed the appliance.