Electrolux U31462 Freezer User Manual


 
818 35 94-01/2 21
Each time one of the two buttons is pressed again the DESIRED temper-
ature is adjusted by 1 °C.
The following DESIRED temperature settings are possible:
• Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps;
• Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps;
Note: From a food safety point of view, -18 °C for the freezer compart-
ment should be considered cold enough as a storage temperature.
3
If the buttons are not pressed again for approx. 5 seconds the tempera-
ture display will change from the DESIRED temperature to the ACTUAL
temperature. The display changes from flashing to illuminated num-
bers.
Important! Please check red warning display and temperature display
regularly to ensure maintenance of the storage temperature.
Switching the Appliance Off
In order to protect frozen goods, the appliance is guarded against
accidental switching off (child-proof).
0 1. To switch off press and hold the ON/OFF button for approx. 1 second.
A so-called "count down" is started in the temperature display, which
counts backwards from "3" to "1". After "1" is reached the appliance
switches off. Illumination at the temperature display goes off.
3
The appliance is only completely disconnected from the electricity
supply when the power plug has been removed from the power outlet.
Note:
The appliance cannot be switched on or off if unplugged, or if there is
no power being supplied to it.
Following connection to the mains power supply, the appliance returns
to the same operating state as before the interruption of main power.
If the appliance is not going to be used for an extended period:
0 1. Switch appliance off by pressing and holding the ON/OFF button for
approximately 1 second (see above).
2. Unplug or switch off at the mains supply.
3. Clean thoroughly (see section: "Maintenance and Cleaning").
4. Leave door open to avoid accumulation of odours.
3
When put into operation again, the appliance starts in the operation
mode, in which it was set prior to switching off.