Filter
Top Products
Reference Manual
00809-0100-4808, Rev CA
June 2008
2-7
Rosemount 3051N
REVIEW
CONFIGURATION DATA
NOTE
Information and procedures in this section that make use of HART
Communicator fast key sequences assume that the transmitter and
communicator are connected, powered, and operating correctly. If you are not
familiar with the HART Communicator or fast-key sequences, refer to
Appendix A: HART Communicator.
Before you place the transmitter into operation, it is recommended that you
review the transmitter configuration data that was set at the factory. You
should review the following configuration data:
CHECK OUTPUT Before performing other transmitter on-line operations, review the digital
output parameters to ensure that the transmitter is operating properly and is
configured to the appropriate process variables.
Process Variables The process variables for the Rosemount 3051N provide the transmitter
output, and are continuously updated. The process variable menu displays
the following process variables:
• Pressure
• Percent of Range
• Analog Output
The pressure reading in both Engineering Units and Percent of Range will
continue to track with pressures outside of the defined range from the lower to
the upper range limit of the sensor module.
HART Comm 1, 5
Transmitter Model Type
Tag Range
Date Descriptor
Message Minimum and Maximum
Sensor Limits
Minimum Span Units
4 and 20 mA points Output (linear or sq. root)
Damping Alarm Setting (high, low)
Security Setting (on, off) Local Zero/Span Keys
(enabled, disabled)
Integral Meter Sensor Fill
Isolator Material Flange (type, material)
O-Ring Material Drain/Vent
Remote Seal (type, fill fluid,
isolator material, number)
Transmitter S/N
Address Sensor S/N
HART Comm. 2