Filter
Top Products
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
Factory temperature
pre-set is 190
˚F.
■■
Disconnect power
from unit.
■■
To adjust water
temperature you’ll
need to access the panel on the front of
the tank. Using a screwdriver, turn
thermostat screw clockwise to increase
temperature or turn counter clockwise to
decrease temperature. The cover must
always be in place for the thermostate to
respond properly.
■■
After adjusting, depress the dispenser
handle for 20 seconds for the water to
re-heat to the new setting. If temperature
still is not to your liking, repeat the procedure
making sure that the handle is depressed
for 20 seconds.
■■
Regularly inspect the unit for any signs of
leakage. If there are signs of water damage,
immediately remove the unit from service.
■■
To avoid water damage from leakage,
replace all cut, loose or split tubing.
■■
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications where
any leakage could cause property damage.
PROPERTY DAMAGE
CARE AND USE
ADJUSTING THE THERMOSTAT
■■
Only use mild cleaners to clean the faucet
and plastic components.
■■
Cleaners with acids, abrasives, alkaline
or organic solvents will result in deterioration
of the plastic components and void
the warranty.
CLEANING THE FAUCET AND TANK
Anytime the instant hot water dispenser is not used
for extended periods of time, unplug and drain unit.
If it is below freezing you will need to unplug the
unit and drain it.
■■
Disconnect power from unit.
■■
Push hot water dispenser faucet lever
and allow water to flow until it is cool.
■■
Shut the cold water flow off at the
shut off valve.
■■
Remove unit from sink and turn upside
down to drain.
SEASONAL STORAGE/DRAINAGE
11
Electric Shock Hazard: To prevent electrical shock,
disconnect power before servicing unit. Use only a
properly grounded and polarized electric outlet.