Filter
Top Products
8
A
4
■■ Bend and position the 1/4" copper
line from the dispenser so it fits into
the cold water supply. With one hand,
support the copper line coming out
of the tank and bend the tube with
the other hand.
■■ Do not kink. Bend tube carefully.
CONNECTING WATER TO DISPENSER
C
B
■■ Push the tube end all the way into
the T-fitting or valve. Hold the tube
end in position and push the ferrule
down as far as it will go. Then,
tighten the nut over the ferrule with
your fingers. Make sure the tube
end is going straight into the hole.
Then tighten the nut firmly with a
1/2" wrench.
■■ When connecting to a compression
type T-fitting or valve, remove the
nut and ferrule (round brass piece)
from the fitting. Then, place the nut
followed by the ferrule over the end
of the tube coming from the
dispenser
.
Ferrule
Nut
Property Damage: Make sure the bends in tubing are
smooth and not kinked. Don’t use paste-type sealants on
water line connections. Tighten compression fittings
snug but don’t over tighten.