Filter
Top Products
Wing Nut Mounting Nut
Rubber Gasket
Brass Nut
Ferrule
Equipment You May Need:
■■ For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this instant hot water dispenser.
■■ This particular unit is not intended for commercial use.
■■ Make sure that all electrical wiring and connections conform to local codes.
■■ A standard 115-volt grounded electrical outlet is required under the sink for the dispenser’s electrical power.
■■ The wall outlet powering your dispenser must have power supplied to it continuously.
■■ This outlet must be fused and should not be controlled by the same wall switch that operates the
disposer, unless you have a SinkTop Switch
™
from InSinkErator
®
.
■■ Moving parts inside the tank causing a rattling noise is normal.
■■ This unit does not contain a drain plug and should not be installed where periodic draining is required,
such as summer homes.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
■ Compression fitting,
T-fitting or saddle valve
■ Adjustable wrench
■ Phillips and flat blade screwdrivers
■ Pencil
■ Tape Measure
■■ Hole punch
■■ Hole saw
■■ Basin wrench
■■ Drill
■■ Level
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and
a 1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line.
See Step 1-B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄4" - 1
1
⁄2" hole saw
made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface
other than stainless steel.
WHAT YOU NEED TO GET STARTED
2
COMPONENTS IN THIS PACKAGE