Filter
Top Products
Installation
7
4.0 INSTALLATION
4.1 References
This document must be used together with site-specific documentation and documentation for other
parts of the system.
4.2 Installation Considerations
Liebert XDCF modules must be securely mounted to the rear of the Egenera BladeFrame cabinet. No
cutting or drilling is required to attach the modules; all mounting holes, slots and pins required are
fabricated at the factory.
If only one Liebert XDCF will be attached to an Egenera BladeFrame cabinet, Liebert recommends
using the lower Liebert XDCF module. If both an upper and a lower Liebert XDCF module will be
attached, attach the lower unit first.
Liebert XDCF modules attach beside the power modules on the rear of the Egenera BladeFrame (see
Figure 6).
Figure 6 Liebert XDCF unit mounting locations