Filter
Top Products
Installation
10
Attaching Liebert XD Flex Pipe Support Panel
Use of only the lower Liebert XDCF module requires attaching a Liebert XD Flex Pipe support panel
and three pipe retainers. The retainers keep the refrigerant pipes behind the Egenera cabinet. If an
upper Liebert XDCF module will be used, the Liebert XD Flex Pipe retainers will be attached to the
upper module.
To attach the Liebert XD Flex Pipe support panel:
1. Position the Liebert XDCF Liebert XD Flex Pipe support panel over the line of four holes above
the right edge of the lower Liebert XDCF module
2. Secure the Liebert XD Flex Pipe support panel to the cabinet by inserting and tightening four
screws on the panel’s flange. Tighten the fasteners securely with a screwdriver, either a Phillips
or a blade-type.
3. Attach the three pipe retainers:
a. Slip the front end of a retainer into a slot on the Liebert XD Flex Pipe support panel.
b. Insert a panel fastener into the retainer and thread it into the captive panel nut.
c. Tighten the fastener securely, using a screwdriver, either a blade-type or Phillips.
d. Repeat Steps a and c for the other retainers.
Figure 9 Liebert XD Flex Pipe support panel attachment
Liebert XD
Flex Pipe
Support Panel
Liebert XD
Flex Pipe
Retainers
Captive Panel
Fastener
Captive
Panel
Nuts
Captive
Panel
Nut
Captive Panel
Fastener
Liebert XD
Flex Pipe
support
panel and
retainers
Lower
CF unit