Filter
Top Products
Combination Detergent & Rinse Aid Dispenser
User Instructions
Detergent Dispenser
Fill the dispenser with detergent unless selecting a
Rinse & Hold program. Gently close the lid. The
detergent will be dispensed automatically during the
wash cycle.
Selecting the Correct Amount of Detergent
Fill the large compartment of the dispenser with
approximately ONE tablespoon of detergent for all
programs.
When running Pots & Pans Wash also place an
additional ONE tablespoons or so of detergent to the
small compartment of the dispenser.
Remember, less than the recommended amount of
detergent is required if the dishwasher is connected
to a soft water supply.
Never sprinkle detergent directly onto tableware.
Always use a detergent made specifically for
automatic dishwashers.
Rinse Aid Dispenser
Use Rinse Aid in the dishwasher to obtain the best
possible drying result while eliminating water spots
on your tableware and glassware. The automatic
Rinse Aid Dispenser releases a measured quantity
of Rinse Aid into the final Rinse segment of each
wash program.
Filling the Rinse Aid Dispenser
To fill the liquid Rinse Aid dispenser, follow these
steps:
1. Open Dispenser «A».
2. Pour the liquid into opening «B» and, without
allowing it to overflow, fill the dispenser.
3. Close the Dispenser.
Always wipe away any drops that may have spilled
outside the dispenser.
Amount to use
For optimum performance, each wash program,
except Rinse & Hold, requires a certain amount of
Rinse Aid be dispensed. The dispenser is factory
preset to automatically dispense 0.07 ounce of liquid
per wash program. Depending on the quality of water,
it may be necessary to adjust the amount dispensed.
To check whether or not the Rinse Aid dispense
volume is properly set, examine your tableware and
glassware following a completed wash program:
• Increase Setting, if there are dried water spots
on the surface of these items.
• Decrease Setting, if there are traces of water
on these items.
Adjusting Rinse Aid Dispense Setting
The dispenser has a CONTROL "C" which regulates
the amount of Rinse Aid dispensed. Rotate the plug
in the container to the position required to adjust the
dosage. The numeric dosage setting corresponds
directly to the volume of rinse aid dispensed. eg.
When the control is pointing at the number " " the
dispenser will emit 0.07 ounce of rinse aid in the final
rinse segment of each wash program.
Rinse Aid Liquid Level
There are two indicators to let you know when the
Rinse Aid Dispenser requires filling:
1. Control Panel Light Indicator - As a convenient
reminder, an indicator light on the control panel will
illuminate whenever the Rinse Aid Dispenser is
empty and requires refilling.
2. Transparent Sight-Glass - The Rinse Aid liquid
level can also be viewed through the SIGHT
GLASS "D". When the sight-glass is completely
"
❍
" CLEAR, the dispenser is empty. A DARK "
●
",
sight-glass indicates there is still Rinse Aid in the
dispenser.
Note: A full dispenser set to dispense level " " should
yield approximately 60 wash programs before refilling
becomes necessary.
Buttons
When buttons are in the “IN” position, they are OFF.
Push buttons out to activate functions.
8
2
2