It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings.
To remove the spray arm, screw off the nut to take out the washer on top of the spray arm and remove the arm. Wash
the arms in soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
Never run the dishwasher without the filters in place.
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficientl
removes food
articles from the wash water, allowin
it to be recirculated
durin
the c
cle. For this reason, it is a
ood idea to remove the lar
er food
articles tra
ed in
the filter after each wash c
cle b
rinsin
the semicircular filter and cu
under runnin
water. To
remove the filter assembly, pull on the cup handle in the upward direction. The entire filter
assembly should be cleaned at least once a month.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble the filter
parts as shown in the figures left and reinsert the entire assembly in the dishwasher, positioning
in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the filter may
reduce the performance level of the appliance and damage dishes and utensils.
Never use a s
ra
cleaner to clean the door
anel for it could dama
e the door lock and electrical com
onents. It is not
allowed to use the abrasive agent or some paper towel because of the risk of scratching or leaving spots on the stain-
less steel surface.
To clean the ed
e around the door,
ou should use onl
a soft warm, dam
ra
. To
revent
enetration of water into the door lock and electrical com
onents, do not use a s
ra
cleaner
of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some papers towels can also scratch or leave marks on the surface.
After every wash, turn off the water supply to the
appliance and leave the door slightly ajar so that
moisture and odors are not trapped inside.
Before cleanin
or
erformin
maintenance, alwa
s
remove the
lu
from the socket. Do not run risks.
To clean the exterior and rubber parts of the dish-
washer, do not use solvents or abrasive cleaning
products. Rather, use only a cloth and warm soapy
water.To remove spots or stains from the surface
of the interior, use a cloth dampened with water
and a little white vinegar, or a cleaning product
made specifically for dishwashers.
When
ou
o on holida
, it is recommended that
ou run
a wash cycle with the dishwasher empty and then re-
move the
lu
from the socket, turn off the water su
l
and leave the door of the a
liance sli
htl
a
ar. This
will help the seals last longer and prevent odors from
forming within the appliance.
If the a
liance must be moved, tr
to kee
it in the verti-
cal position.If absolutely necessary, it can be positioned
on its back.
One of the factors that cause odors to form in the
dishwasher is food that remains tra
ed in the seals.
Periodic cleanin
with a dam
s
on
e will
revent this
from occurring.
