Equator WP 818 Dishwasher User Manual


 
Turn off the water.
Release the water
p
ressure b
y
de
p
ressin
g
the
p
ressure release button. This relieves water
p
ressure and
p
rotects
y
ou, and the
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
3
2
1
This dishwasher is desi
g
ned for o
p
eration on an ade
q
uatel
y
wired individual 120VAC, 60HZ, and
connected to an individual,
p
ro
p
erl
y
g
rounded branch circuit,
p
rotected b
y
a 15 or 20 am
p
circuit
breaker or time-delay fuse.
If the electric supply provided does not meet the above specifications, it is recommended that a
licensed electrician install an approved outlet.
Your dishwasher circuit should not be used for any other appliance while the dishwasher is in
operation as the dishwasher requires the full capacity of the circuit.
If the wall socket
y
ou
p
lu
g
the dishwasher's
p
ower cord into is controlled b
y
a switch, turn on the
switch.
Pull Unicou
p
le and its hoses com
p
letel
y
out from stora
g
e com
p
artment located at rear of dish-
washer and attach it to the faucet adapter.
Turn water fully on before starting the dishwasher.
3
1
If faucet has no threads: attach the faucet adapter to faucet, then tighten every screw of
the adapter. To prevent leaking your should tighten the adapter.
2
Attach the Unicou
p
le connector to the faucet ada
p
ter b
y
de
p
ressin
g
the collar at the to
p
of the connector.
When Unicouple is all the way up onto the adapter, release the collar. It will then snap Into position to
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
'
A hose that attaches to a sink s
p
ra
y
can burst if it is installed on the same water line as the dishwasher. If
y
our sink has one,
it is recommended that the hose be disconnected and hole plugged.
Remove the power cord plug from the wall socket.
Disconnect Unicouple from faucet adapter.
2
1
8