Filter
Top Products
Using Your Dishwasher
Models TUD5000Y (shown)
TUD3000Y
TUD2000W
-
Extra-capacity fold
down shelf
Rack bumper -
- i!
Water inlet opening
4 >
Heating element ’
Spray tower
protector
Silverware basket
Filter system screen
(not shown)
v Lower spray arm
1 Overfill protector
Detergent dispenser
- Access panel
Door color panel
‘Rinse agent dispenser
Model and
serial
number
label (on right side)
Cycle and options (Model TUD2000W)
Wash cycle
Dry Select options
A double wash for moderate to heavily If the HEATED DRYING Option Selector
soiled loads. (The Energy Guide Label data
Button is pushed, air in the dishwasher is
is based on this cycle.) heated during the “dry” part of the cycle.
Select the mark next to WASH with the For best drying results, use a liquid rinse
Cycle Control Knob. The cycle sequence
agent.
will be:
If the ENERGY SAVER Option Selector
Wash-Rinse-Rinse+Wash-Rinse-tRinse-
Button is pushed, air in the dishwasher is
Rinse-Dry-Off
not heated. Using this option helps save
energy, but dishes take longer to dry
(overnight) and some water spotting may
result. Some items (such as plastics) may
need towel drying.
For best drying results, use a liquid rinse
agent.
The drawings in this book may vary slightly
from your dishwasher model. They are
designed to show the different features of
all the models covered by this book.
NOTE: Your model may not include all the
features shown.
Before starting dishwasher
1. Read “Important Safety Instructions” on
page 2 before starting your dishwasher.
2. Properly load the top and bottom racks,
and silverware basket. See pages 4,5
and 6.
3. Spin the lower spray arm to make sure
nothing will stop it from turning freely.
4. Add detergent. See page 6.
5. Check rinse agent dispenser. See
page 7.
6. Push door firmly when closing and it will
automatically latch.
7. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting dishwasher
NOTE: If the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will not
hurt the dishwasher. If you prefer, you can
set cycles with the door unlatched.
1. Select a drying option. (Select ENERGY
SAVER when using the Rinse & Hold
Cycle.)
2. Select any other desired options that are
available. Options may be changed or
cancelled by pushing an Option Selector
Button again.
3. Push the desired Cycle Selector Button,
if needed. (See the cycle descriptions on
pages 3 and 4.)
4. Turn the Cycle Control Knob clockwise to
point to the desired cycle. You will feel a
definite stop at each cycle mark. The
dishwasher will automatically start that
cycle.
Continued on next page
Page 3