Filter
Top Products
14
USING YOUR DISHWASHER
Using the rinse agent dispenser
Rinse agent dispenser
Keep the rinse agent dispenser filled with
a liquid rinse agent. A rinse agent greatly
improves the drying of dishes by helping
water flow off them during the last rinse. A
rinse agent also keeps water from forming
droplets and drying as spots.
To check dispenser
Remove dispenser cap. If dispenser is
empty, an “E” will be clearly visible inside
the dispenser.
The center of the fill indicator cap will be
clear when dispenser needs refilling.
To fill dispenser
You do not have to wait until the dispenser
is empty to refill it, but do not overfill it. The
dispenser will hold 6 ounces of rinse agent.
Under normal conditions, this will last about
three months.
1. Make sure the dishwasher door is
fully open.
2. Remove the fill indicator cap.
3. Add rinse agent to the dispenser. Do not
fill past the smallest opening in the lower
part of the dispenser.
If you overfill, excess rinse agent can
come out. This will not harm the dish-
washer, but could cause over-sudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace the fill indicator cap and keep it
tightly closed.
NOTE: Your dishwasher is designed to use
a liquid rinse agent. Do not use a solid or
bar-type rinse agent.
An “E’’ shows
when empty
R
I
N
S
E
A
I
D
I
N
D
I
C
A
T
O
R
Center will be
clear when
empty
Keep rinse agent
dispenser filled for
best drying results
Do not fill past
smallest opening
Release of a small amount of rinse agent
into the rinse water is automatic in the final
rinse of each cycle. For best drying results,
check the dispenser periodically to see if it
needs refilling.