9
2. For models with cycle selector buttons,
select a wash cycle. See “Cycle selection
chart” for descriptions. For models with
rocker switches, skip to Step 3. The
Rinse Only cycle will operate with any
cycle selector button chosen. The cycle
control knob determines which cycle
operates.
3. Turn the cycle control knob clockwise to
point to the desired cycle.
You will feel a definite stop at each cycle
mark. The dishwasher will automatically
start the cycle you selected.
NOTE: If the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.
Adding a dish during a cycle
You can add an item to the dishwasher
anytime before the knob reaches Light Wash.
1. Lift up on the door latch to unlatch the
door and stop the cycle. Wait a moment
for the spray action to stop before open-
ing the door.
2. Open the door and add the dish.
Changing a cycle setting
You can change a setting anytime during
any cycle. To change the selected option(s):
1. Lift up on the door latch to unlatch the
door and stop the cycle.
2. Turn the cycle control knob clockwise to
the cycle you want.
3. Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
the “Using the detergent dispenser”
section.
NORMAL WASH
LIGHT WASH
POTS & PANS
DRY
RINSE
RINSE ONLY
USE NO HEAT DRYUSE NO HEAT DRY
OFF
Cycles vary with models
3. Close the door. Do not latch it. Wait 30
seconds for air in the dishwasher to warm
up. This helps reduce the amount of
moisture that can come from the vent
when restarting the cycle.
4. Press door in to latch it. The dishwasher
will start where it stopped.
NOTE: Turning the cycle control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section, and close the
cover, if the cycle uses detergent in both
sections.
4. Close and latch the door. The dishwasher
will automatically start the new cycle.
USING YOUR DISHWASHER