Filter
Top Products
13
ENGLISH
Model EDW194E can only be installed with a one-piece custom door
panel that extends from the toe kick to the counter top. The unit comes
with everything needed to make installing the door panel easy. The
door is predrilled for the panel’s mounting screws.
To order a one-piece door, contact your dealer. The part numbers are
listed below:
White 720356200
Black 720356300
Bisque 720356400
Stainless Steel 720356500
ITEMS PROVIDED WITH THE ONE-PIECE DOOR PANELS
These items are supplied with the doors:
♦ One-piece door
♦ Color-coordinated toe kick
♦ Door handle
♦ Handle support bracket
♦ Two 1/2” machine screws for handle
♦ Two 1/2” sheet metal screws for toe kick
INSTALLING THE ONE-PIECE CUSTOM DOOR PANEL
Before fitting the custom panel, the dishwasher must be installed underneath the cabinet.
For this installation, we recommend that you install the 2” fill strip (see page 6) that comes with the unit to hide
the top of the dishwasher and further reduce water noise.
NOTE: Do not fasten the dishwasher to the cabinet until after you have installed the door panel.
1. Remove the custom panel and parts from the packaging.
2. Move the insulation on the back of the custom panel.
3. Slide the handle support bracket to the inside top of the panel.
4. Insert the screws through the support bracket and the panel.
5. Fit the door handle to the screws and secure tightly.
6. Remove the rubber gaskets from inside the dishwasher door and discard.
7. Remove the second and fourth screws from the inside top of the
dishwasher door (as illustrated) and discard.
8. With the door slightly open, position the panel with the holes in
alignment with the door holes and secure it in place with 2-12”
squeeze clamps on both sides.
9. Insert the 1-1/2” screws partially through the dishwasher door.
10. Loosen the clamp on one side enough to align the screws with
the holes in the panel.
11. Secure the screws.
12. Repeat steps 9 and 10 for the other side.
13. Close the door and, if necessary, adjust for square by adjusting
the front levelling legs for proper height clearance.
14. Fasten the dishwasher to the cabinet (see page 9).
FITTING THE EDW194E ONE-PIECE CUSTOM DOOR PANEL
With this
installation, the
custom panel
extends 1-13/16”
inches above the
dishwasher
control panel, as
illustrated.
Dishwasher door
2nd
screw
4th
screw