Filter
Top Products
7
ENGLISH
MOVING THE MACHINE INTO PLACE
WARNING! Make sure you put the slides cups under the legs to prevent damaging the
floor or unit when you slide it into place (see page 5).
1. Remove the zip tie holding the hoses and power supply cord in place
on the back of the unit, as illustrated at right.
2. Position the machine in front of the cabinet opening.
3. Pull out the drain hose to ensure there are no sharp bends.
4. Start to feed water, drain lines, and electric cord (if necessary) into
the access hole in the cabinet.
5. Grip the unit at the top or side edges and gently slide the unit into the
dishwasher opening using the slide cups provided with the unit.
WARNING! Never use your knee or shoulder to push
the unit in place. You could damage the
dishwasher.
6. Check the level and make adjustments if necessary. (See above.)
WARNING! Be careful of sharp edges.
OPENING THE EDW194E CUSTOM DOOR
To open the door panel on the EDW194E, insert your fingers into the
rectangular slots on each side of the door and pull.
ADJUSTING THE LEVELING LEGS
Before you slide the unit under the cabinet, you should adjust the
levelling legs to within 1/8” of the opening height. The four leveling
legs should be adjusted by unscrewing the leg out to the length
required. When the feet are properly adjusted, tighten the
locking nuts to the base pan.
(The machine may have an inclination of 2° maximum without
affecting its performance.)
WARNING! Never lay the dishwasher on its front or
side. When necessary, lay the unit on its
back.
It is advisable to lay the unit on a tarp or
blanket so as not to scratch or damage
the floor or the dishwasher.
Levelling leg
Locking nut