Filter
Top Products
Version 12/04 - Page 5
PREPARE THE WALL
1. Disconnect and move freestanding range from cabinet
opening to provide easier access for installation. Put a thick,
protective covering over cooktop, set-in range or countertop
to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center line
on the wall where the rangehood will be installed.
3. The Pro Magnum attaches to the wall by mounting
screws indicated in FIGURE 5. For the 30" and 36" models,
there are two mounting screws. For the 48" model, there are
four mounting screws. Install the screws into the wall. The
screws should be inserted into the wall until the screw head
is flush with the wall.
WARNING: THE SCREWS PROVIDED FOR MOUNTING
THIS RANGEHOOD MUST BE INSERTED INTO SOLID
WOOD. THESE MUST
NOT BE INSERTED INTO SHEET
ROCK.
Determine the proper location for each bracket and install the
brackets on the wall. MAKE SURE THAT THE SCREWS
AND BRACKETS ARE SECURELY FASTENED TO THE
WALL.
5. Determine and make all necessary cuts in the wall for
the ductwork. The Pro Magnum vents either through the top
or the rear of the rangehood. Each rangehood is shipped from
the factory vented through the top. In order to vent to the rear,
the blower inside the rangehood must be turned to the rear.
The dimensions for the duct openings are given in
FIGURE
8. The 48" model uses two 3 & 1/4" by 10" duct openings.
Install all ductwork before installing the rangehood.
6. Determine the proper location for the Power Supply
Cable as indicated in FIGURE 8. Note that the 30"/36"
versions have the option of top or rear electrical connection
while the 48" version has only the rear option. Use a 1 & 1/4"
Drill Bit to make this hole. Run the Power Supply Cable. Use
caulking to seal around the hole. DO NOT turn on the power
until installation is complete.
FIGURE 8
4. The Telescopic Chimney Kit and Full Width Duct
Cover use different bracket systems to attach to the wall.
FIGURE 6 provides the position for the telescopic chimney
brackets.
48" VERSION
30" AND 36" VERSIONS
FIGURE 7
FIGURE 5
FIGURE 6
FIGURE 7 provides the dimensions for the Full Width Duct
Cover brackets. The Full Width Duct Cover also attaches to
the top of the rangehood with screws provided. The Full Width
Duct Cover must be attached to the top of the rangehood
before mounting the rangehood to the wall.
Electrical Opening
Electrical Opening
If a backsplash is to be used with this rangehood, it must be
installed before the rangehood. Installation instructions for
the backsplash are supplied in its box. The height of the
backsplash will determine the bottom edge of the canopy.