Filter
Top Products
9
DESCRIPTION OF TIMER
Steps for setting and Timing the Heat Source
With the radiant cooktop switched on:
1 Choose the required power of the heat source that you wish to time.
2 Switch on the timer by touching the sensor +. Once on the timer display
appears and appears in the display of each heat source.
3 Touch the + of the chosen heat source. will flash in the display of the chosen
heat source. The timer has now been set to the chosen heat source.
4 Choose the desired time pressing + which corresponds to the timer.
Once these steps have been carried out the setting sequence of the heat source
timer ends.
If between each step there is a pause of over 10 seconds or if you do not choose a
length of time, the timer will automatically switch itself off
Once the timer has been set to a heat source and the time has been chosen, the timer
will gradually count down the time and will indicate the time remaining to switch off the
heat source.
During the timing, in the heat source display you can see the selected power and the
(indicating that this heat source is timed) alternatively. Once the time has passed the
heat source will switch itself off, the control will release a warning acoustic signal and
will flash in the timing display. Touch any sensor control to stop the warning signal.
Cancelling the timer
Touch the sensor of the timer until is shown on the minute display.