Filter
Top Products
18
LCD Norm Fast Deli Rinse Hardware Output
-------------------------------------------------------------------------------------------
bL Off Off Off On Backlight
Er Off Off On Off Element Relay (turns off after 5 seconds)
Ld Off Off On On Lid Motors (will run for 10 seconds)
dd Off On Off Off Detergent Diverter Valve
FU Off On Off On Fill Water Valve
P1 Off On On Off Motor Wash direction 2300-2850
rpm
(will not run if the tub is open)
P2 Off On On On Motor Drain direction 4200 rpm
(times out after 255 seconds.)
rd On Off Off Off Rinse Aid Dispenser (
dispenses according to current user setting)
dF On Off Off On Drying fan
LE On Off On Off Rinse Aid and Salt Tank LEDs
C1 On Off On On Water Softener Diverter Valve
C2 On On Off Off Water Softener Brine Pump
C3 On On Off On Water Softener Brine Valve
°C On On On Off Displays current water temperature.
°E On On On On Displays controller rail voltage
(C3 is used in the factory to empty the water softener before the product is packed.)
Tub Home Sensor Test: At any time during HO test mode the Keylock symbol on the LCD display (Keylock LED on
integrated badge) indicates the tub position. On = closed, off = open.
Press POWER to skip hardware diagnostics and exit mode.
5.1.3
Fast Test Cycle – Level Three
WARNING : Only run this cycle if connected to the water supply.
This level runs an 8-minute fast test cycle.
Flat door and Integrated will show the following LED’s on secondary display panel
.
Pre Finished Integrated and Flat Door Models
Will show the following LED’s on secondary
display panel
Press POWER to skip Fast Test Cycle and advance to the next level.
Press START/PAUSE to enter Fast Test cycle.