Filter
Top Products
19
Once the fast test cycle is selected, the DishDrawer™ goes into standby mode and 8 minutes will be showing on the
display. The test cycle is started by pressing START/PAUSE, and the following components are run during the 8 minute
cycle that follows: - Lid motors, fill valve, wash motor, element, drain motor, drying fan.
Press POWER to exit at any time.
The test sequence in fast cycle mode performs 33 tests. The number of any failed test is displayed on the touch switch
panel LEDs. The test sequence continues even if a test fails. If there are multiple failures the LEDs will change during the
test.
5.1.4
Continuous Cycle Test Mode – Level Four
Not required for testing of F9 related faults.