Filter
Top Products
COOKTOP DIMENSIONS CLAMPING DOWN COOKTOP
TYPE LENGTH WIDTH DEPTH Place the cooktop into the cutout
CT560X 578mm 511mm 51mm and tighten with the supplied clamps.
CT560C 578mm 511mm 51mm
CT5602F 578mm 511mm 51mm These will cope with bench thickness
CT2802 289mm 511mm 55mm 15-50mm.
CT6552S
(Cooktop) 578mm 511mm 45mm
(Controls) 88mm 511mm 63mm
BICT600 578mm 511mm 45mm
CT6552S Control Box Installation
· Remove the brackets from the cooktop and the box.
· Place the cooktop in the cutout.
· Feed the cooktop wiring harness up through the box cutout.
· Remove Control Box cover.
· Connect the cooktop wiring harness.
· Clamp the wiring harness.
· Wire the mains to the box and clamp.
· Replace Control box cover.
· Roll the box into the cutout.
· Secure control box and cooktop using brackets provided.
Note: Two small brackets are provided that screw to the sides of the control box. These
must be used to clamp the control box down to the joinery. Three brackets are
provided for clamping down the cooktop.
Part No. 599049B September 2000
Cooktop Cutout Dimensions
MINIMUM DEPTHS
CT560X 60mm
CT560C 60mm
CT5602F 60mm
CT2802 60mm
CT6552S 65mm
BICT600 50mm
50mm
20mm
min.