Filter
Top Products
8
Installation instructions
Cabinet preparation
Make sure that the countertop is flat and level and that no structural members interfere with
space requirements.
Make sure the countertop is made of a heat resistant material.
We recommend that the exposed bare wood edges of the cutout be sealed with an oil based
paint or moisture-proof polyurethane to prevent possible damage from moisture creeping
between the cooktop trim and the countertop.
Electrical
Make sure that there is a power supply receptacle (110-120V 60Hz) within reach of the cooktop
power supply cable (30” from the middle of the product). The power supply cable must not
touch any hot metal parts.
Make sure the cooktop is connected to a power supply socket that is electrically grounded
in accordance with local codes or in the absence of local codes, with the National Electric
Code ANSI/NFPA 70 or CSA C22.2 (Canada). The power supply socket must be accessible after
installation.
The power supply must be properly polarized. Reverse polarity will result in continuous sparking
of the electrodes, even after flame ignition. If the power supply is not properly polarized, it is the
responsibility of the customer to have the polarity corrected.
If there is any doubt as to whether the wall receptacle is properly grounded or polarized, have it
checked by a qualified electrician prior to installing the cooktop.
This appliance is equipped with a three-prong grounding plug for your protection against shock
hazard and should be plugged directly into a properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
US
CA
EN