Filter
Top Products
12
Installation instructions
Fastening the cooktop to the bench
1
With the cooktop turned upside down, mount the supplied front and rear clamps (F and R) and
screws (S) onto the cooktop, as shown (without tightening the screws).
2
Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the
bench.
3
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the benchtop.
Note: if your bench is thicker than 40 mm, recess the underside to between 20 and 40 mm.
20
mm min.
40
mm max.
S
F
F
F
R
R
20
mm min.
40
mm max.
S
R
FRONT SIDE
Seal A
Seal A
Seal C
Fig. 4 Fastening the cooktop to the bench
Gas inlet pipe
Rear side
Front side