Filter
Top Products
4
Using your cooktop
Lighting the cooktop
1
Choose the control knob for the burner you want to use.
2
Press down gently and turn the knob anticlockwise to
the High position. You do not need to hold the knob
down. The electrodes on all the burners will spark.
Note: For the first burner selected there is a short delay
before the safety valve allows gas to flow to the cooktop.
3
Adjust the flame anywhere between the High and Low
positions. Do not adjust the flame between High and Off
O.
Note: If the burner does not light within 5 seconds, turn
the control knob off before trying again.
If the cooktop does not light
If the cooktop does not light, check that:
The cooktop is plugged in and the electricity is switched on.
The gas is turned on.
You have allowed at least five seconds for the safety valve to open when lighting the first burner.
The electrodes are sparking.
If the electrodes are not sparking, they may be dirty or wet. Clean them with a toothbrush and
methylated spirits, as shown in Fig. 3.
-0
-0
)*)*
0''
0''
High
Low
Off
Burner
ON
light
Fig.2 Burner knob
Fig.3 How to clean an electrode
Electrode