40
START HERE
Try to open the drawer
(without using excessive force).
Press
on the wash
program panel to stop
the beeping, then
follow the applicable
instructions below.
Press and hold
until you
hear a quick double beep.
Do the fault code indicators
and beeping come back in a
few seconds?
Check which program indicators
are lit on the wash program panel.
Look up what fault code the
indicators correspond to in the
table opposite.
Note down the code here:
Press
on the wash program panel.
The Eco indicator and another set of
program indicators will briefly light
up. Mark which ones in the diagram
below. This information will help
Fisher & Paykel identify the fault more
precisely. Which other indicators light
up when you press
?
YES
NO
If it’s an ‘E’ code
Can the drawer be opened?
Disconnect the
dishwasher from the
power supply to stop
the beeping, then
contact Customer
Care. See your
‘Service and warranty’
booklet for contact
details.
How to attend to a fault ‐
Integrated models with remote control
Disconnect the dishwasher from the
power supply (unplug or switch off at
circuit breaker), turn off its water supply,
then contact Customer Care with the
fault code information. See your ‘Service
and warranty’ booklet for contact details.
U1: Turn on the water supply,
press
, then close the drawer to
resume the wash program.
YES
NO
If it’s a ‘U’ code
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
You have corrected the fault and can
continue to use your dishwasher as normal.
You have corrected
the fault and can
continue to use
your dishwasher as
normal.
U4: Attend to the fault on
the other drawer. The drawer
displaying U4 is not faulty.
NO
NO
YES
YES
U6: Open the drawer and check the
spray arm.
Has the spray arm loosened or
come off its mounting?
Water pressure
is too low. You
may need to have
a ‘4 litre’ valve
installed on your
water supply.
Refit the spray arm
following instructions
in section ‘User
maintenance
instructions’, then close
the drawer and press
to resume the wash
program.