Filter
Top Products
- 35 -
6.4 Detergent Dispenser
6.4.1 Remove the drawer front and handle as per instructions in 6.1.& 6.2
6.4.2 Disconnect the two wiring loom connections off the dispenser coils.
Note: Push back locking tabs to allow connectors to release.
6.4.3 Unclip the retainer flap at the bottom center of the dispenser and
slide out the rinse aid level LED.
6.4.4 Unclip the fill hose on the dispenser
6.4.5 While holding the dispenser unscrew the six T10 Torx drive screws
securing the brackets around the dispenser.
6.4.6 The dispenser can now be removed from inside the tub.
6.4.7 The coils can be replaced as a spare part by sliding them off the
armature.
6.4.8 To open up the dispenser door fully, first open the door using the
release catch then squeeze the top sides of the door. This will release
the door to the fully open position. This can be done with the
dispenser in place.
6.4.9 Refit in reverse manner ensuring the dispenser gasket is located
correctly.
6.5 Electronic Controller
6.5.1 Remove the drawer front and handle as per instructions in 6.1.& 6.2.
6.5.2 Placing a finger either side of the top sides of the controller, pull it
forward until the controller clears the top edge of the tub.
6.5.3 Disconnect the wiring connectors down the left side of the
controller.
6.5.4 The controller can now be tipped down to 90° from it’s original
position. This will allow the disconnection off the lower wiring
connectors and the two and three wire looms from their wire duct.
6.5.6 The controller can now be lifted clear.
6.5.7 Refit in reverse manner.
6.6 Top Kick Strip Removal
6.6.1 Pull out the lower drawer.
6.6.2 Place both hands under the top kick strip.
6.6.3 Pull the bottom of the top kickstrip forward quickly.
6.6.4 Tipping it right up will allow the top locating tabs to drop out of the
tub inserts.
6.6.5 Refit in reverse manner ensuring it is clipped into place.