Filter
Top Products
- 2 -
1.1.6 Insulation Test
Megger test to check insulation.
Warning: Short together the phase and neutral pins on the
plug so as not to damage any electronic circuitry.
1.1.7 Solvent and Excessive Heat Damage
Plastic surfaces can be damaged by solvents and excessive
heat.
1.1.8 Sheet Metal Edges
When working around cut sheet metal edges use appropriate
gloves or protection to eliminate the chance of receiving a
laceration.
1.1.9 Diagnostics
While in diagnostics some safety devices are bypassed.
Ensure you do not run components unattended. They may
overheat, flood, burnout or cause water damage.
D